1 / 3
Panasonic NV-GS90 camcorder battery
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Its battery replacement for panasonic nv-gs90 camcorder. Maybe it fits other camcorders.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 209
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
Beside printed parts you will need:
- soldering iron
- electrical or kapton tape
- two 13400 li-ion cells (from disposable vapes)
- LX-LISC-V2 usb-c 2s li-ion charging board
- super glue
Please don't buy your cells. Just pick them up from curbside near local school.
Case - print standing on wall with usb hole. If you confident with your bridging game you can do it without support.
Spacer - print standing up, fork side up. Brim strongly advised, tree supports under overhangs.
Lid - flat side to bed, easy peasy
15% triangle infill, 2 walls, PET-g
Assembly:
- Take 2, single stranded, wires and strip about 4cm of one end. Fish them through holes in the case and back. Use needle nose pliers and twist wires tightly.
- Solder twisted wires. Use a LOT of flux always.
- Bend the wires toward front face and tape it with electrical tape or better - kapton tape
- Solder 13400 cells in series. Use longer wire, we need it for balancing cells.
- Place PCB inside spacer. Place it on li-ion cells. Use electrical tape for easier work. Solder balancing wire FIRST. Then solder wires to B+ and B- on PCB. Finaly solder wires to positive and negative of battery.
- Remove tape and put battery inside case.
- Solder remaining wires to B+ and B- pads on PCB. Thats good (and last) moment to test if everything works ok.
- Glue lid on and its done :)