RGB Headphone Stand /Headphone Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is RGB headphone stand that i designed because there wasn't any that i liked
- Ocena
- 4,5 / 5
- Polubienia
- 20
- Pobrania
- 88
- Wydruki
- 3
- Wyświetlenia
- 1999
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
You will need Arduino nano
ws2812b Ledstip about 20cm/8in
long Tactile button min. 6mm
(or you can use 3d printed Optional button )
Few cables
5v usb male conector (you can use cable with male connector from old charger)
Assembly : step 1 : first you need to solder cables to ledstrip and then stick the ledstrip to the base (run the cables through the hole)
step 2 : connect cables and program the arduino nano (use the youtube video as a guide , start at 5min. But instead of conecting stepdown modul , connect usb cable to arduino )
step 3 : Screw Arm to the Top part using M4x10 (PS : if you printed Top as separate parts you need to superglue them together )
step 4 : superglue Base and Top assembly together (make sure the arduino and cables stick out from bottom hole)
step 5 : drill 5mm hole in the top mesh to fit the button and then glue the button from bottom to the hole (I didn´t have long tactile button so i printed button extender, you can find it in the models)
If you would need some help you can ask me in the coments.