RGB Headphone Stand /Headphone Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is RGB headphone stand that i designed because there wasn't any that i liked
- Rating
- 4.5 / 5
- Likes
- 20
- Downloads
- 88
- Makes
- 3
- Views
- 1,999
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial
You will need Arduino nano
ws2812b Ledstip about 20cm/8in
long Tactile button min. 6mm
(or you can use 3d printed Optional button )
Few cables
5v usb male conector (you can use cable with male connector from old charger)
Assembly : step 1 : first you need to solder cables to ledstrip and then stick the ledstrip to the base (run the cables through the hole)
step 2 : connect cables and program the arduino nano (use the youtube video as a guide , start at 5min. But instead of conecting stepdown modul , connect usb cable to arduino )
step 3 : Screw Arm to the Top part using M4x10 (PS : if you printed Top as separate parts you need to superglue them together )
step 4 : superglue Base and Top assembly together (make sure the arduino and cables stick out from bottom hole)
step 5 : drill 5mm hole in the top mesh to fit the button and then glue the button from bottom to the hole (I didn´t have long tactile button so i printed button extender, you can find it in the models)
If you would need some help you can ask me in the coments.