Naked Gopro Hero 6 BetaFPV TBS ND Filter Holder No Vignetting!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I meticulously designed this to where it will fit with little to no light leaks and removes all vignetting!
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Print in TPU, if its not a well calibrated print then expect very minor vignetting. This model is pushing the edge of vignetting. Install with 3 self tapping screws into the case. These screw holes were designed intentionally super small so that they self tap into the TPU mount. I suggest pre-installing the screws with lots of pressure until they are almost all the way through the print. If there is slight offset when getting the third screw installed onto the case, pull and guide with your fingers to keep it going in straight into the hole (it was hard to model this extremely accurate).
KEEP IN MIND: This was not tested in superview. I am sure most of us are aware, but normal wide view works better for Gyroflow. If you still get minor vignetting almost all of it should be hidden with stabilization so don't fret :) black TPU printing is suggested to avoid colored reflecting.