Naked Gopro Hero 6 BetaFPV TBS ND Filter Holder No Vignetting!
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I meticulously designed this to where it will fit with little to no light leaks and removes all vignetting!
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 14
- Makes
- 0
- Views
- 113
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Print in TPU, if its not a well calibrated print then expect very minor vignetting. This model is pushing the edge of vignetting. Install with 3 self tapping screws into the case. These screw holes were designed intentionally super small so that they self tap into the TPU mount. I suggest pre-installing the screws with lots of pressure until they are almost all the way through the print. If there is slight offset when getting the third screw installed onto the case, pull and guide with your fingers to keep it going in straight into the hole (it was hard to model this extremely accurate).
KEEP IN MIND: This was not tested in superview. I am sure most of us are aware, but normal wide view works better for Gyroflow. If you still get minor vignetting almost all of it should be hidden with stabilization so don't fret :) black TPU printing is suggested to avoid colored reflecting.