1 / 3
Umarex HDR50 Holster - Belt Spacer
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
replacement belt width spacer for Umarex HDR50 belt holster
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 790
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (20)Powiązane
A simple replacement spacer to adjust the belt width in the Umarex HDR50 holster. Fits without glue in a loose friction fit and is high enough to jam against clip when closed. (See pictures)
Printable in PLA with no problems.
Settings I tested and use for my holster:
Infill: 15%
Layers: 0.2mm
Filament: PLA
Either print as in model with supports on pin side or rotate to one of the long flat sides and print with overhangs.