1 / 1
H2T Solar Mod - Case of Heltec T114 with Solar Panel
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add a tiny solar panel to keep the H2T battery topped up
- Ocena
- 5 / 5
- Polubienia
- 38
- Pobrania
- 114
- Wydruki
- 3
- Wyświetlenia
- 2229
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 3) (Komentarze: 6)Remiksy (1)Kolekcje (60)Powiązane
The Heltec T114 has both a battery input and a solar input:
Purchase list:
- Solar Panel: https://www.digikey.com/en/products/detail/anysolar-ltd/KXOB101K08TF-TR/13999136
- Connector: https://www.amazon.com/dp/B07FP2FCYC
- Some Kapton Tape (Optional): https://www.amazon.com/dp/B072Z92QZ2
Instructions:
- Solder Connector to the solar panel try to center the wires and be careful these wires are tiny!

- Add the solar panel shims and the Kapton Tape. Use the tape to keep the wires in the channel

- Place the battery in and route the wires. The wires I used was just barely long enough, so it will be tight. Make sure to connect the wires accordingly it is labeled on the PCB

Done! Some bright sunlight and everything should be great!
