Tinmorry Spool Adapter - Ender 3v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
TINMORRY FILAMENT SPOOL ADAPTER - 31/54 Customised using openSCAD as thingiverse is just plain broken. This is a…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 107
- Wydruki
- 0
- Wyświetlenia
- 810
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
TINMORRY FILAMENT SPOOL ADAPTER - 31/54
Customised using openSCAD as thingiverse is just plain broken.
This is a customised print for a loose fit on a standard ender 3v2 spool holder, but nice and tight in the Tinmorry spool.
IMPORTANT NOTE: Due to the design of the spindle on the v2, you cannot simply slide these on !!!!
To make these work, I cut the end off the back of the tube at the cuff. I drilled a single hole through the tube to allow me to fit a split pin or similar to stop any chance of the filament spool sliding off.
Combining 2 of these withPTFE tape wrapped around the ender spindle provides a nice, low friction solution without the cost of bearings etc.
Inside Diameter of adapter: 31
Outside Diameter of adapter: 54
Arm spring 1.4mm
6 arms straight.
Printing Guide
You can print with/without a brim - I used a brim as the arms have a tendency to want to warp, but usually stay down fine for the print, but brim cleanup is pretty trivial.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
No
Supports:
No
.2
Infill:
10
Filament:
Tinmorry PLA Black
Notes:
Customised using openSCAD as thingiverse is just plain broken.
My attempt to use customiser, when I can get it to even load (not in Chrome on Linux, only on IPAD Chrome) the queue never processes the work ...Category: 3D Printer Parts