1 / 6
Jowo #6 fountain pen with cap liner — zdjęcie 1
1 / 6

Jowo #6 fountain pen with cap liner

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Created by request from someone who wanted to know if I could make a separate cap liner in my Jowo #6 fountain pen.

Ocena
0 / 5
Polubienia
12
Pobrania
43
Wydruki
1
Wyświetlenia
341
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Based on my previous model https://www.printables.com/model/747037-jowo-6-fountain-pen

This is a fountain pen that uses a Jowo #6 nib unit & Standard International Cartridge/converter. You will have to purchase those separately. I recommend the Opus 88 units available from JetPens, but any Jowo #6 housing should work.

 The clip is installed with one M2.5 flat head screw 6mm long such as McMaster-Carr part 92010A016

I like to chase the threads with a M7.5x0.5 tap. It helps if you're printing with an Ender 3. With a printer like the Bambu, when I tested it, no tap was needed. 

Tough PLA works best as regular PLA can be brittle.

Print with a 0.4mm nozzle max. Adaptive layer height down to 0.1mm because there's fine detail on all of the parts. Your printer needs to be well-calibrated to print this accurately.

I like to run the calibration cube here before I run a set of pens to check my flow. https://www.printables.com/model/81314-flow-calibration-cube 

Print all parts with the largest flat face down and use a brim on all except the clip. No support should be necessary. 
Print them one at a time for the best result to reduce stringing. You will need to deburr/chamfer the bottom edge with a sharp knife or sandpaper just to ensure a proper fit and removal of the brim. 

Because the print will still be somewhat porous and not seal as well as a traditional resin, I've found that Private Reserve Infinity Inks work best. Dipping the section to fill is not recommended since the section will absorb and stain. I prefer to syringe-fill converters or use cartridges. 

This model includes a new cap liner which can be printed in a softer material such as TPU in 90-95 Shore A. After printing, secure it with a M2.5 screw inside the cap. 

 

Nib https://www.jetpens.com/Opus-88-Fountain-Pen-Nib-JOWO-6-Medium/pd/31472

Converter https://www.jetpens.com/Schmidt-K5-Fountain-Pen-Converter/pd/14478 

Screw https://www.mcmaster.com/92010A016/ 

Optional Tap https://a.co/d/gLraTUo or https://a.co/d/6wNBDB9 

My preferred material: https://a.co/d/eajXGC3 

Alternate material which holds up better to abuse https://a.co/d/1mE55Dd 

Tagi