1 / 6
Jowo #6 fountain pen with cap liner — image 1
1 / 6

Jowo #6 fountain pen with cap liner

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Created by request from someone who wanted to know if I could make a separate cap liner in my Jowo #6 fountain pen.

Rating
0 / 5
Likes
12
Downloads
43
Makes
1
Views
341
Reviews
0

Updated at source:

Model information

Category
Office
License
Creative Commons — Attribution — Noncommercial — Share Alike

Based on my previous model https://www.printables.com/model/747037-jowo-6-fountain-pen

This is a fountain pen that uses a Jowo #6 nib unit & Standard International Cartridge/converter. You will have to purchase those separately. I recommend the Opus 88 units available from JetPens, but any Jowo #6 housing should work.

 The clip is installed with one M2.5 flat head screw 6mm long such as McMaster-Carr part 92010A016

I like to chase the threads with a M7.5x0.5 tap. It helps if you're printing with an Ender 3. With a printer like the Bambu, when I tested it, no tap was needed. 

Tough PLA works best as regular PLA can be brittle.

Print with a 0.4mm nozzle max. Adaptive layer height down to 0.1mm because there's fine detail on all of the parts. Your printer needs to be well-calibrated to print this accurately.

I like to run the calibration cube here before I run a set of pens to check my flow. https://www.printables.com/model/81314-flow-calibration-cube 

Print all parts with the largest flat face down and use a brim on all except the clip. No support should be necessary. 
Print them one at a time for the best result to reduce stringing. You will need to deburr/chamfer the bottom edge with a sharp knife or sandpaper just to ensure a proper fit and removal of the brim. 

Because the print will still be somewhat porous and not seal as well as a traditional resin, I've found that Private Reserve Infinity Inks work best. Dipping the section to fill is not recommended since the section will absorb and stain. I prefer to syringe-fill converters or use cartridges. 

This model includes a new cap liner which can be printed in a softer material such as TPU in 90-95 Shore A. After printing, secure it with a M2.5 screw inside the cap. 

 

Nib https://www.jetpens.com/Opus-88-Fountain-Pen-Nib-JOWO-6-Medium/pd/31472

Converter https://www.jetpens.com/Schmidt-K5-Fountain-Pen-Converter/pd/14478 

Screw https://www.mcmaster.com/92010A016/ 

Optional Tap https://a.co/d/gLraTUo or https://a.co/d/6wNBDB9 

My preferred material: https://a.co/d/eajXGC3 

Alternate material which holds up better to abuse https://a.co/d/1mE55Dd 

Tags