1 / 2
TopRC Odyssey KingMax KM1203MD Adaptor to Standard Servo Size — zdjęcie 1
1 / 2

TopRC Odyssey KingMax KM1203MD Adaptor to Standard Servo Size

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Servo Adaptor Plate to install the KingMax KM1203MD 10kg Servo's of only 20 grams per piece

Ocena
0 / 5
Polubienia
0
Pobrania
21
Wydruki
0
Wyświetlenia
140
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

Servo Adaptor Plate to install the KingMax KM1203MD 10kg Servo's of only 20 grams per piece, to be used for the elevators, rudder and ailerons, for the flaps I chose the KST CM653 40 gram servo, saving in total 235 grams of unnecessary servo and accessory weight.

I printed these in Extrudr GreenTEC Pro Carbon and infused the prints with ultrathin CA for additional tensile strength and temperature resistance.  Weight of one adaptor is 3.5 grams completely infused.  I position the servo exactly to the place where the horn will meet the control rod and then with thick CA I set it locked in place and later on use fine screws to secure even further.  In total this adds another 2 grams of glue and screws totaling 25.5 grams per servo installation compared to 65 grams for a normal servo.

Use the PowerBox special weight saving servo leads to gain more weight in the plane as a whole, only the signal wire is a lot thinner, power lines remain thick enough so no compromises or added resistance.

Printed with 4 top and bottom layers, 3 outline perimeters and 50 percent gyroid infill.