1 / 2
TopRC Odyssey KingMax KM1203MD Adaptor to Standard Servo Size — image 1
1 / 2

TopRC Odyssey KingMax KM1203MD Adaptor to Standard Servo Size

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Servo Adaptor Plate to install the KingMax KM1203MD 10kg Servo's of only 20 grams per piece

Rating
0 / 5
Likes
0
Downloads
21
Makes
0
Views
140
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Servo Adaptor Plate to install the KingMax KM1203MD 10kg Servo's of only 20 grams per piece, to be used for the elevators, rudder and ailerons, for the flaps I chose the KST CM653 40 gram servo, saving in total 235 grams of unnecessary servo and accessory weight.

I printed these in Extrudr GreenTEC Pro Carbon and infused the prints with ultrathin CA for additional tensile strength and temperature resistance.  Weight of one adaptor is 3.5 grams completely infused.  I position the servo exactly to the place where the horn will meet the control rod and then with thick CA I set it locked in place and later on use fine screws to secure even further.  In total this adds another 2 grams of glue and screws totaling 25.5 grams per servo installation compared to 65 grams for a normal servo.

Use the PowerBox special weight saving servo leads to gain more weight in the plane as a whole, only the signal wire is a lot thinner, power lines remain thick enough so no compromises or added resistance.

Printed with 4 top and bottom layers, 3 outline perimeters and 50 percent gyroid infill.