INRI Plaque
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nuns from a convent asked my wife if she could find an INRI plaque for their outdoor cross. Turns out they were very…
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 105
- Wydruki
- 1
- Wyświetlenia
- 222
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution
Nuns from a convent asked my wife if she could find an INRI plaque for their outdoor cross. Turns out they were very expensive, so I said I'd try to design and 3D print one. So this is the result. There are 2 models - one that is attached with double faced tape and one that has a recessed screw hole with a cap to hide the screw. Just put a little glue on the cap and press it in. It is about 7 inches wide but you can resize it in your slicer. I printed it at 0.2mm, 10% fill, monotonic top (in Cura), and turned on ironing.
Print Settings
Rafts:
No
Supports:
No
0.2
Infill:
10%
Category: Signs & Logos