INRI Plaque
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Nuns from a convent asked my wife if she could find an INRI plaque for their outdoor cross. Turns out they were very…
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 105
- Makes
- 1
- Views
- 222
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution
Nuns from a convent asked my wife if she could find an INRI plaque for their outdoor cross. Turns out they were very expensive, so I said I'd try to design and 3D print one. So this is the result. There are 2 models - one that is attached with double faced tape and one that has a recessed screw hole with a cap to hide the screw. Just put a little glue on the cap and press it in. It is about 7 inches wide but you can resize it in your slicer. I printed it at 0.2mm, 10% fill, monotonic top (in Cura), and turned on ironing.
Print Settings
Rafts:
No
Supports:
No
0.2
Infill:
10%
Category: Signs & Logos