1 / 2
Powder Bottle Stacker Ring
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple ring that fits around the top of a 1lb smokeless powder bottle so that they can be stacked on top of each other.
These were printed with standard PLA, 10% Cubic Infill, No Supports, with an 8mm Outer Brim.
Note: Because the base is so narrow (to save print time and material), and the top is proportionally larger, good bed adhesion is a must. I have been successful using just an outer brim, but if you have problems, use both an inner and outer brim and make the brims fairly large.
I am including the step file so that you can resize as needed.