1 / 2
Powder Bottle Stacker Ring
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple ring that fits around the top of a 1lb smokeless powder bottle so that they can be stacked on top of each other.
These were printed with standard PLA, 10% Cubic Infill, No Supports, with an 8mm Outer Brim.
Note: Because the base is so narrow (to save print time and material), and the top is proportionally larger, good bed adhesion is a must. I have been successful using just an outer brim, but if you have problems, use both an inner and outer brim and make the brims fairly large.
I am including the step file so that you can resize as needed.