Tamiya Super Avante Rear Upright
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rear upright for Tamiya Super Avante (TD4)
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 147
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
A disappointing outing and week waiting on replacements caused me to test my skills at making my own replacement. Hours in tinkercad with nothing but the original part and set of calipers led to this.
It's fits, it's on my own TD4, but it's has yet to be tested.
If someone else has a broken Super Avante test them out with me.
Printed in petg, with organic supports set to everywhere.
0.15mm layer height worked well, 3 or 4 walls, high infill 60% or higher.
Print standing for a better bearing fit, or laying down on it's side for a stronger hinge pin hole.
Hinge pin may need drilling with a 2.6mm drill bit.
Fender flare drill holes with a 1.5mm drill bit.
Ball connector hole tap with a 3mm tap if needed
(drill with 3.2 mm drill bit on countersunk version).
Two versions:
One for the standard threaded ball connector.
Second with a countersunk hole for a countersunk m3 screw and 5mm ball connector nut.
New version up, adds slight reinforcement.