RAK Wisblock Meshtastic Solar Window Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Window mountable mount for the RAK Wireless Wisblock LORA/Meshtastic radio. This can hold a solar panel and battery.
- Ocena
- 0 / 5
- Polubienia
- 32
- Pobrania
- 82
- Wydruki
- 0
- Wyświetlenia
- 1864
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
This is a window mountable, solar recharging unit for the Wisblock Meshtastic radio. It uses 4 suction cups to mount to the window with no holes, and holds a 5 watt solar panel to keep everything topped up.
All parts should be printed in ABS or another material that can withstand direct sunlight. Printed at 25% infill, so supports should be needed. Rafts recommended on the larger parts to prevent lifting.
Printed parts list
1X Solar Frame
1X Main Enclosure
1X Cover
1X Battery Clip
4x Cable Management Tabs
Purchased parts list:
Solar Panel:
https://www.amazon.com/dp/B09CYWCCCY?
Screw Kit:
https://www.amazon.com/dp/B07ZH9GJWP
WisBlock:
https://store.rakwireless.com/products/wisblock-meshtastic-starter-kit?variant=43884034621638
M6 Bolt:
https://www.amazon.com/Socket-Stainless-SG-TZH-Spanner/dp/B0BDY9ZNJJ
Battery:
https://www.adafruit.com/product/328
Suction cups:
https://www.lowes.com/pd/Hillman-Clear-Suction-Cup/1000037815
Note on battery, I used this Adafruit battery as I had one laying around, but realistically there is enough room on the battery mount to use any LIPO that is smaller or the same size.
Remove the metal hooks from the suction cups and attach them to the solar frame. There are small detentes that will secure them in place.
Lay the solar panel under the frame, and fish the USB cable through the largest hole on the Main Enclosure.
Use four M2.6x6 screws to secure the enclosure to the frame. Use the M6 bolt to secure the solar panel on. Note that the solar panel is not symmetrical so you may need to rotate it to get the bolt hole to line up properly. 
Attach the Cable Management Tabs to the posts in the corner, they should press fit and be snug enough to keep their position. 
Loop the length of the solar panels USB cable around the posts and under the tabs in a U shaped pattern.
Use the cut out at the bottom of the enclosure to pass the USB cable through, and make sure to attach the included Micro-USB to USB-C adapter.
Use four M2.6x6 screws to secure the Wisblock to the frame. Feed the antenna pigtail through the hole at the top. Make sure to attach your antenna.
With you antenna connected, connect the USB power cable and your battery to the Wisblock.
Attach a small piece of double sided tape or foam to the Battery Clip.
Use three M2.6x6 screws to secure the Battery Clip over the battery.
Use four M2.6x8 screws to attach the back cover.
Stick the unit to the nearest sunny window and see you on the mesh!