Apple Keyboard + TrackPad holder (3 part variant)

Apple Keyboard + TrackPad holder - 3 part variant for smaller printers. It is the same model as my 2 part variant, but on user request here are the files spilt in 3 parts to be printed on smaller printers too. =)

Apple Keyboard with number block and TouchID + TrackPad holder to keep the 2 devices together as one. Should fit the current devices well. =)

The 3 parts are screwed together with the M3 screws and the 2 connector plates.

Super simple print! =)

Video of the 2 part variant:

Notes:

• You can add rubber feet to the bottom. You will find round 12mm cutouts.
• Cutouts for the nuts and screws should make connecting the pieces easy.
• Will work for left or right hand use because of the flat design. =)

Printing instructions:

• No supports needed
• Using a brim could help if you face problems with adhesion. Feel free to add a 5mm brim.
• 0.2 speed profile.
• Textured sheet used:
  • If you use a textured sheet too, let it cool down completely after the print and wait for the part gets loose by itself. Do not pull on it to avoid ripping off the letters! 
  • In my case it takes 45-90 minutes after the print has ended and the part just lays loose on the print bed.
  • Do not touch the print bed and clean it with Isopropanol alcohol before printing.

Parts needed:

• 28x M3x6 screws
• 28x M3 nuts

Happy printing =)