FlyDiGi Vader 3 and 4 Pro Back Paddle Mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an easy to install mod to replace the back buttons with paddles on the Vader 3 & 4 Pro gaming controller.
- Ocena
- 5 / 5
- Polubienia
- 47
- Pobrania
- 407
- Wydruki
- 5
- Wyświetlenia
- 2867
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an easy install paddle modification for both the FlyDiGi Vader 3 and 4 Pro gaming controller. This is a drop in replacement for the rear buttons on controller. Simply remove the 4 screws from the rear of the controller, pry the controller apart at the seam, remove the plastic spring (buttons attached), and replace it with this print. This will require 4 m2*6 screws.
I find these most comfortable when printed in lower layer heights (.08 or .16) but they could be printed at whatever resolution you desire.
This print requires supports. There is a version that does not require supports included in the files, but it removes the posts that are used to pivot the buttons. This print usually works fine but can give some problems. I do not recommend this version.
I have also included a file with the paddle ends not yet attached. This can be used to easily move the paddle location to fit anybody's preference. I suggest using Fusion360s loft feature.
This can be purchased through this link
https://vader4pro.notus.gg/
Install walkthrough video:
https://www.youtube.com/watch?v=cY32_36pInw&ab_channel=Notus