1 / 1
Z-Wave RGBW Controller Enclosure
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An enclosure for a Zooz/Fibaro RGBW controller and a DC barrel connector.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 229
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is an enclosure designed for the Zooz Zen31 or Fibaro RGB Controller 2 (FGRGBW-442). It also supports a female DC barrel connector for power.
- The DC barrel connector a tight fit, so you'll want to push down firmly on the connector to install.
- This can support other devices of the same general size, but it is untested.
- The holes in the enclosure help with airflow and signal strength.
- The horizontal slit next to the barrel jack is designed to fit a 22 AWG 5 conductor wire.
- Supports mounting two 15x2mm neodymium magnets on the bottom for easy mounting.
Recommended Print Settings
This is a fairly simple print, but these seem to work the best for me:
- 0.2mm Layer Height
- No Supports
- 15% Infill