1 / 4
ADT UT3G EGPU Enclosure - 250mm GPU + 120mm Slim Front Fan Support
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified version of the original which allows for longer graphics cards, a 120mm front fan, and the Enhance 7660b PSU.
- Ocena
- 4 / 5
- Polubienia
- 42
- Pobrania
- 393
- Wydruki
- 1
- Wyświetlenia
- 4207
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 1) (Komentarze: 12)Remiksy (2)Kolekcje (50)Powiązane
This is a slightly modified version of the original ADT LINK UT3G USB4 eGPU enclosure with the following changes:
- Adjusted height and length to support most dual-slot GPUs up to 265mm in length
- Adjusted width to fit a slim 120mm front fan (reduces GPU length to 250mm)
- Added small vent cutouts to the rear to allow better airflow for 120mm front fan
- Added support for Enhance 7660b PSU with a larger rear cut-out and side ventilation
Notes:
- I used an INNO3D 4070 Super and Enhance 7660b PSU from Velkase
- This PSU needed an adaptor for the nvidia 12VHPWR plug - I used this adaptor from AliExpress which worked well and does not heat up much
- 120mm fan has exactly 2mm width clearance. This allows it to be mounted using 1mm-thick adhesive silicone strips on each side of the fan which create a perfect friction fit. No screws needed.
- Graphics card backplates are not compatible - this was an oversight and could be easily fixed, though.
- Another small hole was drilled into the central vertical plate to allow for cable ties - this could also be added into the model itself.