1 / 2
BambuLab P1S/X1C Slim Poop chute 30mm — zdjęcie 1
1 / 2

BambuLab P1S/X1C Slim Poop chute 30mm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

P1P "Poop" chute with a slim desing for printers that have the rear against a wall

Ocena
5 / 5
Polubienia
36
Pobrania
277
Wydruki
1
Wyświetlenia
1302
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I found the "Poop" (purge) chutes shared online overly complicated and bulky.

My printer sits on furniture with very limited depth so I designed this chute to fit in the space left between a common 90 degree PSU cable and the wall. That is less than 30mm of space to work with. This chute has a total depth of 26mm, not counting the adhesive tape.

To pick up the purges from the chute you can place any box you want in the corner. I am using a 2x1x4 Gridfinity bin as in my case this is all hidden behind a filament dryer so design is not very important.

To install the chute use two 20x10 mm strips of double sided tape and place them in the slots.
Remove the adhesive protectors, align the top chute corner with the bottom left corner of the purge opening and stick the chute to the rear panel of the printer.

For reference, I used Tesa Powerbond tape as it's fairly easy to remove if needed.

Tagi