Microphone anti-shock stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Anti-shock stand for Yeti microphone by Blue designs.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 17
- Wydruki
- 2
- Wyświetlenia
- 395
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Public Domain
Anti-shock stand for Yeti microphone by Blue designs.
A friend of mine complained that his mic registers vibration from his keyboard (located on the same desk), so I went on to make this to isolate the mic from the desk.
I printed it on Prusa i3 MK2S, 0.2mm layer height with PLA.
The rubber legs are anti-vibration stands that I got laying around. I used springs I bought in a set at my local store, I have no idea about their specs. But it's not important that the legs are made from rubber, as the anti-shock function is primarily achieved by springs. You can print any cylinder to replace them, though I'd suggest an anti-slipping sticker on bottom.
The thing ended up better than expected, the mic is suspended about 3 mm above desk. But this height can be further lifted by using washers between the rubber stands and base part.