1 / 6
"Fat Bear" Wire Strain Relief (Umbilical) for the Orbiter 2.0 with Orbiter Filament Sensor Attached. — zdjęcie 1
1 / 6

"Fat Bear" Wire Strain Relief (Umbilical) for the Orbiter 2.0 with Orbiter Filament Sensor Attached.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is the first strain relief bracket for the Orbiter 2.0 that allows for the Orbiter filament sensor to be attached.

Ocena
0 / 5
Polubienia
10
Pobrania
33
Wydruki
0
Wyświetlenia
406
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Hello,

I had an Orbiter 2.0 with the filament sensor add-on, and I needed to add strain relief for my umbilical.  I could not find an Orbiter 2.0 strain relief model that added a port to accommodate the Orbiter filament sensor wire harness.  So, I designed one!!

Features:

-Snug Fit

-Uses Threaded Heat Inserts

-Pass-Through Port for Orbiter Filament Sensor Wire Harness

-Beefy Strain Relief Block With Curved Channel

-Accommodates 3 Small Zip Ties 

-Looks Like a Cute, Fat Bear.

 

Even if you aren't printing ABS or ASA in an enclosed chamber, I still recommend printing this out of ABS or ASA in the event that your Orbiter Extruder remains extremely warm during your printing.

Print in the orientation you see in the model preview (ring flat against bed). You may not need to use supports depending on how well-tuned your printer is, but it definitely wouldn't hurt to use them,

Just add 2x M3 threaded heat inserts and 3 zip ties and you're ready to Rock and Roll!

 

I am using this on my XOL toolhead on my Voron 2.4 350mm, but I designed it to interface only with the Orbiter 2.0 and Filament Sensor body, so it should be toolhead agnostic.

 

If this helped you, please comment and share in your favorite communities!

 

Peace Out!

 

Tagi