Paper Towel Holder With Internal Supports for Strength - Updated
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Paper towel holder with internal support bosses between the base and vertical bar portion for added strength.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 118
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
January 18, 2025 Update
V2: I made the vertical bar taller and increased the diameter. I found that I was grabbing the top part with my other hand when pulling off the paper towels, a bit more height makes this easier. 3mf V2 file has includes both models.
--------------------------------
I had printed a few other paper towel holders and they were weak where the base and vertical bar meet. Due to how the slicers work, there is only infill under the vertical bar and not much to hold it in place. I modeled thin slots into my design to add two internal supports that print all the way from the bottom of the base to a bit higher than the start of the vertical bar for some added strength.
The 3mf includes 65% infill for the base to make it heavier to keep the overall center of gravity lower. I finished the top with Archimedean Chords for a nicer finish.
I also added a non-slip gripper pad to the bottom.
https://www.amazon.com/gp/product/B000SL0KJM
Printed in 0.2mm layer height, this one is marble PLA, it should print well in almost any material. It is tall yet fits on my Prusa XL. If your print volume is not high enough it can be cut with connectors in most slicing programs.