Upgraded dust port for Grizzly G0453E planner.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted a six-inch dust port on my Grizzly G0453E planner to do a better job of extracting the dust that it makes.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 172
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a six-inch dust port for my planner to up the game on the dust collection. After designing it I had to split it in half because it was way too big for the MK4. At the split I added material for several screws to hold the two parts together. So far, it works great. I wasn't sure if it would be strong enough, but it has held up fine. When I run boards through the planner I get almost no visible dust.
I've included the my initial partial print which I used to test the fit at the opening of the planner where the dust port attached, because it was a bit busy. After a couple tries I was close enough to print the modle.