Upgraded dust port for Grizzly G0453E planner.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I wanted a six-inch dust port on my Grizzly G0453E planner to do a better job of extracting the dust that it makes.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 25
- Makes
- 0
- Views
- 175
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a six-inch dust port for my planner to up the game on the dust collection. After designing it I had to split it in half because it was way too big for the MK4. At the split I added material for several screws to hold the two parts together. So far, it works great. I wasn't sure if it would be strong enough, but it has held up fine. When I run boards through the planner I get almost no visible dust.
I've included the my initial partial print which I used to test the fit at the opening of the planner where the dust port attached, because it was a bit busy. After a couple tries I was close enough to print the modle.