Miniature Painting Handle - End Cap/Lid

I love the design of the handle, but felt like it was a missed opportunity to have a lid for the bottom so you could actually store the adapters inside, rather than having them float around. The ideal solution would probably to thread the inside of the handle and have a threaded end cap, but this does the job.

Opens with relative easy as long as you don't jam it in there, if you do, you'll need something with a thin edge to wiggle it out a bit.

I used my Bambu P1S to print this and it fits perfectly and stays in place, depending on the tolerances of your printer, your results may vary.