Nissan Magnetic Phone Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Loved the idea of magnetic phone holder. Changes from original1) now uses nine (9) 8x4mm magnetcs.2) Cover slides on…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 138
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Loved the idea of magnetic phone holder.
Changes from original
- now uses nine (9) 8x4mm magnetcs.
- Cover slides on instead of glue
- Made the cover thinner where the magnets are, now it is 0.2mm thick
I printed the cover first 3 layers at 0.1mm so I could get two (2) layers at the thin part. Then the rest of the layers on the cover at 0.2mm thick. The main part was printed at 0.2mm. If your slicer cannot switch layer heights mid print then just print the whole cover at 0.1mm just takes longer but gives best results on the thin area.
I would recommend printing supports on the cover, but I forgot and it turned out just fine. :)
Print Settings
Printer:
Modified CR-10s
Rafts:
No
Yes
Resolution:
0.1
25
Filament: Amazon Basics PETG Black
Category: Automotive