Deadpool Helmet stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Recently printout Deadpool and Wolverine masks and needed a stand. So I put this together.
- Ocena
- 0 / 5
- Polubienia
- 111
- Pobrania
- 318
- Wydruki
- 1
- Wyświetlenia
- 4163
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Recently printout Deadpool and Wolverine masks and needed a stand. So I put this together.
You will need a 3/4 inch wood dowel cut to your preferred length.
Plaque - has a notch in it so it can be glued on the base at an angle. You can also glue it facing straight up on the base if you like. I paused the print for the color change on mine.
I did use supports on the notch in the plaque.
base-bottom.stl - This doesn't need to be printed unless you are gluing the eyes on like I did. It is only 2mm thick so adjust the Z height in your slicer if you need it thicker.
Wolverine helmet can be found here - https://www.printables.com/model/1025137-wolverine-helmet-stand
Print Settings
- Printer brand: Longer
- Printer: Longer LK5 Pro
- Rafts: No
- Supports: Yes
- Resolution: .2
- Infill: 10
- Filament brand: Esun
- Filament color: Ruby Red
- Filament material: PLA
- Notes: I printed everything but the plaque at .28 to save some time.
Plaque was done at .2