Fiery Phoenix - Single Extruder - Dual Colour
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Phoenix made in 2 parts to combine in 2 colours
- Ocena
- 5 / 5
- Polubienia
- 76
- Pobrania
- 256
- Wydruki
- 1
- Wyświetlenia
- 1024
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Phoenix made in 2 parts to combine 2 colours sections.
Hi all,
This model is a little bit tricky to set up to print, so would recommend looking at the photos attached for the best results. You need to set up the angles and supports in the areas shown and I used tree support at 60 degrees
For those of you using Cura I've also saved the project files .3mf so this should provide the correct angle and supports automatically. You should be able to import model into Cura ,not sure if .3mf work for other slices ( Let me know if it does )
I also added a temporary base to the feet to hold everything together when printing this can be simply cut off after print.
TIP- if you are struggling with the fine details try reducing your retraction settings. I know your'll have more stringing but this does help.
Enjoy :)
*Note* - just tried on Bambu studio the .3mf files open in the right angles however the support blocks are normal blocks so you need to make sure to turn these support towers.