KlackEnder Ender 3 v2 Microswiss NG Revo

Remixed kevinakasam's klackender to work with the MicroSwiss NG Revo DD for the ender 3 v2.

• The probe dock magnet and screw positions had to be adjusted for the lower revo nozzle.
• The probe mount had to be adjusted to fit the microswiss carriage and made to sit a little lower so the revo nozzle doesnt hit the bed.

Used the latest STL's and CAD from his github page.

Adjustments for the Revo variant

[probe]
pin: ^PA7
z_offset: 3 #Measure per your specific setup. Klipper will NOT save this value if this in not located in printer.cfg
x_offset: 6.5 # negative = left of the nozzle
y_offset: 31 # negative = in front of of the nozzle
speed: 5.0
lift_speed: 15.0
sample_retract_dist: 1
samples: 2
samples_tolerance_retries: 6

[gcode_macro PROBE_CALIBRATE]
rename_existing: _PROBE_CALIBRATE
gcode:
    {% if not 'xyz' in printer.toolhead.homed_axes %}
    G28
    {% endif %}
    PROBE_OUT
    G90
    G1 Z20
    G1 X111 Y86.5 F12000 ; Readjust for center of bed adjusted for probe offset
    _PROBE_CALIBRATE
    TESTZ Z=20
    M117 Remove the Klack to continue calibration!

[gcode_macro PROBE_ACCURACY]
rename_existing: _PROBE_ACCURACY
gcode:
    {% if not 'xyz' in printer.toolhead.homed_axes %}
    G28
    {% endif %}
    PROBE_OUT
    G90
    G1 X111 Y86.5 F12000 ; Readjust for center of bed adjusted for probe offset
    _PROBE_ACCURACY
    PROBE_IN