1 / 4
Rod and Tube Cutter for Dremel — zdjęcie 1
1 / 4

Rod and Tube Cutter for Dremel

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Rod and Tube Cutter for Dremel

Ocena
4,667 / 5
Polubienia
1195
Pobrania
2050
Wydruki
11
Wyświetlenia
13 438
Oceny
9

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a tool to cut small diameter rods or tubes using a Dremel. I use it with a Dremel 395. It has the Dremel thread (M18x2,25/ANSI 3/4-12) in the guide part, so you can just easily screw the Dremel in. You will need a small tube or rod with a 10mm diameter to connect the two parts. The guide part might need some sanding to fit in the base, I wanted it to fit nicely with little play.

I also made an imperial system version for the hinge. You can use a 3/8" axle for the hinge instead of the 10mm axle. The files with "_38" in the filename are the 3/8" axle version. I hope the tolerances are okay to fit the axle in.

Also added a support-block, for supporting the loose end of the tube/rod to be cut.

Tagi