Rod and Tube Cutter for Dremel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rod and Tube Cutter for Dremel
- Rating
- 4.667 / 5
- Likes
- 1,195
- Downloads
- 2,053
- Makes
- 11
- Views
- 13,457
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a tool to cut small diameter rods or tubes using a Dremel. I use it with a Dremel 395. It has the Dremel thread (M18x2,25/ANSI 3/4-12) in the guide part, so you can just easily screw the Dremel in. You will need a small tube or rod with a 10mm diameter to connect the two parts. The guide part might need some sanding to fit in the base, I wanted it to fit nicely with little play.
I also made an imperial system version for the hinge. You can use a 3/8" axle for the hinge instead of the 10mm axle. The files with "_38" in the filename are the 3/8" axle version. I hope the tolerances are okay to fit the axle in.
Also added a support-block, for supporting the loose end of the tube/rod to be cut.