Apple TV remote with AirTag slot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Apple TV remote with AirTag slot
- Ocena
- 4 / 5
- Polubienia
- 4
- Pobrania
- 26
- Wydruki
- 1
- Wyświetlenia
- 407
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a way to combine these two techs....but mostly WHERE IS THE DANG REMOTE!
You must print it at .2mm or .1mm for this print to work!
It has very tight tolerances, so print a little slower or scale the whole thing up 1-3% if you run into issues. The holes in the back are for charging and removing the remote if you need to. When putting in the airtag, put the shiny side down first. You should be able to replace the battery then without removing the remote.
There are two spots hidden within the base of the remote for magnets if you would like to add them. The bottom layer is .2mm thick...or one layer. So the magnets are VERY close to the skin and work perfectly in my experience. I had round 8mm x 3mm tall neodymium magnets that I used. Just put a pause in the slicer before your 3d printer covers that area up and slip in your magnets. The cavity is 3.2mm tall, so it shouldn't cause any print strikes if you put the pause in correctly.
Good luck!