Cat Back Scratcher
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Share Alike
This is a simple little print for your cat so that it will not have to rub up against your leg over and over and over again, but can still scratch itself. You can also set it on the ground where it can roll and roll it with your foot. This was designed fully in TinkerCAD, renderings done in Fusion.
No supports needed!
If your printer can handle it, extend the Z axis in your slicer. Print the base part, set it where you want it to go, fill it with water or sand, and put the lid on. That's it!
If you enjoy this, please like, comment, follow, or check out some of my other models at: https://www.printables.com/@BuckyKatt129