1 / 5
MMU3 buffer holder with leg R4 (to fix back of the buffer) — zdjęcie 1
1 / 5

MMU3 buffer holder with leg R4 (to fix back of the buffer)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Better attachment of the MMU3 buffer to the MK4/S printer (front and back)

Ocena
0 / 5
Polubienia
6
Pobrania
51
Wydruki
0
Wyświetlenia
262
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0

The MMU3 buffer is attached to the printer on a single point (front of the buffer) by means of the buffer-holder-R4.

Depending the filament spool arrangement and keeping the bowden tubes as straight as possible, the buffer gets twisted and there is some force applied to the buffer-holder-R4 printer attachment point.

To stabilize I combined the back leg and front buffer holder to allow to attach the back of the buffer to the printer too.

There are following mounting variants:

  • buffer-holder-leg-short-belowPSU-R4: Attaches on the back of the MK4/S main frame (below the PSU, or behind the PSU at the very back) → Original buffer position
  • buffer-holder-leg-belowZStepper-R4: Attaches on the front of the MK4/S main frame (below the Z stepper) → More in front buffer position (if there is no room at the back)

Print same as the original Prusa parts using PETG (Jet Black), 0.20mm STRUCTURAL, 20% infill.

Please leave a comment and make photo!