Ortlieb bag wall mount.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Make 2 to hold one bag.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 54
- Wydruki
- 1
- Wyświetlenia
- 796
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Simple wall mount for Ortlieb bags. 4 pieces total per mount. Assembles with 6 M3 hex head screws. Supports only needed for pin. Sides print on their sides with 6mm pin hole vertical with chamfered side or hole on print bed.
4 - M3 16 or 18 and 2 - M3 20
For my print I made the pin from a piece of 8mm x 44mm brass rod stock, and made 7mm on each end be 6mm in diameter. Chamfered and polished. Did this on a small hobby metal lathe. Any 8 to 9mm round stock could be used. I think this is stronger than a plastic printed pin for this use.
I've included a pin for 3D printing, print laying down, not on end. Use supports for the pin.
may need some cleanup to fit the holes.