Ortlieb bag wall mount.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Make 2 to hold one bag.
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 54
- Makes
- 1
- Views
- 796
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Share Alike
Simple wall mount for Ortlieb bags. 4 pieces total per mount. Assembles with 6 M3 hex head screws. Supports only needed for pin. Sides print on their sides with 6mm pin hole vertical with chamfered side or hole on print bed.
4 - M3 16 or 18 and 2 - M3 20
For my print I made the pin from a piece of 8mm x 44mm brass rod stock, and made 7mm on each end be 6mm in diameter. Chamfered and polished. Did this on a small hobby metal lathe. Any 8 to 9mm round stock could be used. I think this is stronger than a plastic printed pin for this use.
I've included a pin for 3D printing, print laying down, not on end. Use supports for the pin.
may need some cleanup to fit the holes.