Yard Force Classic 500 6xBlade Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapterplate which allows to mount 6 blades on the existant rotorplate with bigger outerdiameter.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 410
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an adapter for the Yard Force Classic 500 mower
Maybe something for your Openmower project.
Inspired by this adapter from @Mike_1420074
Unfortunately, it was too small for my mower.
You can mount 6 blades, increase angular velocity and mowing area.
It will also get a bit louder.
Two versions are available, with 190mm and 203mm outerdiameter (+blades).
If you are using the standard blades the big adapter will fit perfect (pic attached). With longer blades, you should choose the smaller disk.
Fins and no fins version
The fins was meant to blow the leaves in autumn time to the side, which worked out quite well with set up 100 perimiters in the software.
To find out if it fits, simply measure the distance between two blade screws, it should be 114mm.
My existing base plate measures a little less than 150mm.
One of the available variants is with fins. I thought the airflow would blow the leaves to the side even better, but that doesn't seem to be the case.
You will need
- 6x M4 self-locking nut
- 6x M4x12 BHS screws
- 3x additional blades
- 3x Existing M4 screws for adapter fastening
You can get a box with 60 blades and special screws for 10,99€ if you're located in Germany, which are doing the job very good.
Amazon Link 60 blades for 10,99€
Better are these screws, dont know how to look for these
Printed it with PETG
- 0.2mm layer
- 30% infill hexagon
- 4 walls,
- 4 top and 4 bottom layers