Programming jig for GHome WP9 Z2-N-v1.1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a jig for the Z2-N-v1.1 in the GHome WP9 power strip, matching the pads on the edge of the board.I use it,…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 54
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a jig for the Z2-N-v1.1 in the GHome WP9 power strip, matching the pads on the edge of the board.
I use it, along with ltchiptool, to read/write the firmware, ultimately installing OpenBK.
You'll need to clear the holes with drill bits (I use these). I believe the bit I'm using is the "1.0mm" bit (it's the second smallest in the set of micro drill bits), the shaft measures 0.86mm in my caliper.
I use these pogo pins.
I've included the CadQuery source code for the jig. It's not particularly fancy, but it got the job done.
Print Settings
Printer Brand:
Prusa
Printer:
MINI+
Yes
Resolution:
0.20 Quality
15%
Filament: Prusament PETG
Notes:
The pin holes end up being "suggestions" that need to be cleared with a small drill bit.
Category: Electronics