Programming jig for GHome WP9 Z2-N-v1.1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a jig for the Z2-N-v1.1 in the GHome WP9 power strip, matching the pads on the edge of the board.I use it,…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 9
- Makes
- 0
- Views
- 53
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This is a jig for the Z2-N-v1.1 in the GHome WP9 power strip, matching the pads on the edge of the board.
I use it, along with ltchiptool, to read/write the firmware, ultimately installing OpenBK.
You'll need to clear the holes with drill bits (I use these). I believe the bit I'm using is the "1.0mm" bit (it's the second smallest in the set of micro drill bits), the shaft measures 0.86mm in my caliper.
I use these pogo pins.
I've included the CadQuery source code for the jig. It's not particularly fancy, but it got the job done.
Print Settings
Printer Brand:
Prusa
Printer:
MINI+
Yes
Resolution:
0.20 Quality
15%
Filament: Prusament PETG
Notes:
The pin holes end up being "suggestions" that need to be cleared with a small drill bit.
Category: Electronics