Locking Anchor for 3/8" x 3/4" Miter Slot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Locking anchor for a standard 3/8" x 3/4" miter slot. Does not have T-slot found on some miter slots.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 224
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Made to fit a 3/8" x ¾" miter slot on a Kreg router table to hold jigs and such.
Printed in PETG, 100% infill, a few perimeters, 0.2mm layer height.
Uses a 5/16-18 counter sunk screw for taper clamping mechanism. Pictures show a Rocker knob used to test it on the router table. Any knob would do though. Takes a few turns to get the screw to start to grip, but once it starts to tighten, it gets tight! With this tight in the Kreg router table's non-t-slot miter slot, I can move my router table cart around, and it doesn't slip. Feels very solid.
(Since this is for dangerous power tool, use at your own risk.)