LaserMATIC MK II and MK II XW Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple handle for a Roly Automation LaserMATIC MK II/MK IIXW
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 135
- Wydruki
- 0
- Wyświetlenia
- 400
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is just a simple handle I made for my MK II XW. I also added a 2nd version that doesn't have the center support hole for the original MK II. These require no additional hardware. I design parts at a very close tolerance so your printer will need to be tuned correctly.
I print these upside down flat with supports everywhere. I printed these in ASA with 15% Infill, 5 Layers Side and Top and it seems to be plenty sturdy for this application. PLA should be fine too.
(For the MK II, skip to the removal of the acrylic cross bar.)
Installation is fairly simple. Remove the 4 screws and metal center support from the front of the lid. Remove the metal center support and install it in the new handle between the 2 grooves. Make sure you install this correctly as the holes should be closer to the top. Then remove 2 screws on both ends of the acrylic crossbar. While moving the crossbar out of the way, slide the handle in place so the center metal support screw holes are aligned with the holes in the acrylic. Put the acrylic crossbar back in place and replace the screws on both ends. I didn't remove the crossbar completely. I removed 3 screws and loosened the 4th, then moved it enough to slide the handle in place. Then re-install the 3 screws and tighten the 4th. Don't forget to install the 4 screws back in the metal center support.
That's it. Enjoy.