1 / 6
LaserMATIC MK II and MK II XW Handle — image 1
1 / 6

LaserMATIC MK II and MK II XW Handle

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple handle for a Roly Automation LaserMATIC MK II/MK IIXW

Rating
0 / 5
Likes
12
Downloads
135
Makes
0
Views
401
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

This is just a simple handle I made for my MK II XW. I also added a 2nd version that doesn't have the center support hole for the original MK II. These require no additional hardware. I design parts at a very close tolerance so your printer will need to be tuned correctly.

I print these upside down flat with supports everywhere. I printed these in ASA with 15% Infill, 5 Layers Side and Top and it seems to be plenty sturdy for this application. PLA should be fine too.

(For the MK II, skip to the removal of the acrylic cross bar.)

Installation is fairly simple. Remove the 4 screws and metal center support from the front of the lid. Remove the metal center support and install it in the new handle between the 2 grooves. Make sure you install this correctly as the holes should be closer to the top. Then remove 2 screws on both ends of the acrylic crossbar. While moving the crossbar out of the way, slide the handle in place so the center metal support screw holes are aligned with the holes in the acrylic. Put the acrylic crossbar back in place and replace the screws on both ends. I didn't remove the crossbar completely. I removed 3 screws and loosened the 4th, then moved it enough to slide the handle in place. Then re-install the 3 screws and tighten the 4th. Don't forget to install the 4 screws back in the metal center support.

That's it. Enjoy.