Vape cart and battery stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Combo cart and battery stand
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 179
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
Hello all, this is my first uploaded make! This is a combo stand for carts and the accompanying battery device. For those pen style batteries that don't stand on their own to prevent the concentrate from lining the side. It was especially an issue when getting low and having to prime and wait or hit it with heat in order to get it to flow back down. Now it just stays at the bottom, ready to go. My battery measured at about 11.6mm in diameter and cart just under 11mm.
Model with feet uses 6mm x 2mm rubber to keep from sliding around if on a smooth surface like a bedside table. This one is a little more generous with the sizing so you can fit multiple batteries as they fit in the smaller holes as shown in the picture.
Snug model is slightly tighter and does not have the feet cutouts(if you need the extra grip you can scale the feet model to 95%). The battery will not fit in the holes intended for the carts but it will be a nicer fit and if tipped over will not fall, at least mine didn't when I knocked it and even held until about 160 degrees upside down.
Hopefully someone finds this useful, happy printing!