BIQU H2 Anycubic i3 Mega mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
easy to print, ultra lightweight
- Ocena
- 5 / 5
- Polubienia
- 31
- Pobrania
- 267
- Wydruki
- 1
- Wyświetlenia
- 3447
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Best to use ABS ASA or PETG.
perimeter 3, layer 0.2mm 15% infill.
After removing the old Hotend completely this slides on the bearings without loosing the rails again.
You can use the original hotend fan. As well i used the original heater and temperature sensor for the hotend. Normally the BIQU H2 is delivered with 24V fan and heater. so if want a matching fan you need to buy a 35mm fan for 12V.
The original duct fan is to weak for fast printing so i am using a radial fan 5015.
Two different Ducts. If you use a BLtouch you need the back mounted one.
The system is printing very reliable.
Additional parts
See photo
radial fan 5015
If you just want to improve your Anycubic with standard Extruder see:
https://www.prusaprinters.org/prints/60561-anycubic-big-fan-mount
Housing i use:
https://www.prusaprinters.org/prints/47885-box-jellyfish-3d-printer-enclosure-ikea-lack-table