Mirrored Solder Fume Extractor w/ Dual Filters
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the original Fume Extractor by Hugo White. It mirrors the cable cutouts and moves geometry as needed.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 1
- Wyświetlenia
- 337
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
THIS IS A WORK AND PROGRESS, FURTHER DOCUMENTATION WILL FOLLOW
NEXT STEPS:
1. Find a new off-the-shelf potentiometer or design my own PCB to handle it.
Background:
I was quite impressed with the usability of the solder fume extractor by HugoWhite, but I saw quite a few people suggest that the Noctua Fan chosen simply wasn't powerful enough to overcome the filters. So I went a little over the top and chose the Delta THB1212B-AXHF. The original Noctua NF-F12 iPPC-3000 has 186.7 m³/h of Airflow and can produce 7.63 mm H₂O of Static Pressure using 3W of Power. The Delta THB1212B-AXHF has 184.2 CFM (309.6m³/h) of Airflow and 22.84 mm H₂O of Static Pressure with 19.3W of Power.
But with power comes issues: The first is that the fan does not come with pre-crimped leads, so you will need to do that. It also pulls air from the opposite direction of the Noctua. This meant that if I used the original models, it would blow at my fumes instead of pulling them into the filters.
This project seeks to mirror the original model and make and other geometry changes necessary. It will also document the changes to the required electronics. The 12V decoy seems to handle the current just fine, as well as the other components. However, the original potentiometer I ordered does not have a high enough resistance value to actually tame the airflow of the fan, so it does nearly nothing. I will investigate that change and find out if I can get the new potentiometer in the same footprint.
I remodeled the base plate to be thicker and have recesses for anti-slip pads. This fixes an issue I had where the fan was blowing itself along my desk. For the pads, I used “1" (25mm) Slipstick Gorilla Pads” such as these: https://www.amazon.com/dp/B08C373VBW
