Horizontal BTT SKR Mini E3 Corner Case for 2020 Extrusion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Horizontal BTT SKR Mini E3 Corner Case for 2020 Extrusion
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 259
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I wanted a horizontal mount for the SKR Mini E3 V2 to act as a secondary MCU for Tronxy X5SA Pro build. It needed to be in the front right side so it could be hooked to a display.
Printed in PLA using Voron print specifications. Supports may be required depending on your part cooling.
Parts:
-4 to 5 M3 screws length 8-16mm to mount motherboard to bottom
-4 x M3x25mm screws through top into bottom
-4 x M3 nuts/locknuts for bottom
-4 to 5 x M5x10mm for tabs
-4 to 5 x hammer nut or equivalent for 2020
Optional Parts:
-40mm fan grill
**Please note that the 40mm fan will either mount to the top or the bottom with 2 screws. The top and bottom will then close the gap.
**I used the BTT SKR Mini E3 V2, but the V2 and V3 are supposed to have same layout. I have not been able to confirm it with this model.
**This could be used vertically depending on use case.